Home Thermal Spray Equipment Combustion Powder Combustion Wire Twin Wire Electric Arc Thermal Spray HVOF Plasma System Comparisons SprayBug Powder Feeder Rotating Disk vs Fluidized Bed Powder Feeder Handling Equipment Used Equipment Materials Wire Thermal Sray Wire Listing by Material Type Thermal Spray Wire Aerospace Approvals Thermal Spray Wire by Applicaiton Thermal Spray Wire by Tafa Cross Reference Powder Eutectic Powder Video vaulted video P-Met 720 AT400 twin wire electric arc thermal spray system assembly Load and spray wire AT400 electric arc thermal spray Intro to Thermal Spray Laser Cladding Information Who We Are SevenHabits.1 Articles Thermal Spray Wire Surface Preparation for thermal spray coatings Blog

Combustion Powder

PowderJEt 85.2

PowderJet 85

A combustion powder system uses a combustible gas mixed with oxygen to create a flame outside of the spray gun of approximately 5500 F. This is the heat source to melt the material to be sprayed. The material to be sprayed is in the form of a powder that is fed into the center of the flame where it is melted. Once it is melted in the flame, the liquid metal is atomized from a combination of the pressure from the flame and compressed air that is injected around the flame. The atomized molten metal now forms a columned stream, similar in appearance to a spray paint pattern, except this is molten metal. The molten stream of metal is deposited on the component to be coated at a thickness of .0005" (.0127mm) per pass to .003" (.0762 mm) per pass. The variation of thickness per pass is depended on the material being sprayed and the amount of heat build up on the part being coated.

The complete system includesthe combustion powder gun complete in a metal case, gas flow meters, air flow meters, air trio, airjet assembly, vibrator, transformer, gas regulators, and flash back arrestors. When you purchase the complete system from us we include a set of free hoses.

pps2gf pps2af

PPS-2GF PPS-2AF

The PPS-2GF will control oxygen and fuel and is required to control the flow of gases for the WireJet series and the PowderJet series of guns. It is a direct replacement for theMetco 2GF. The standard system is configured to use acetylene and oxygen, optional hardware is available to use propane, propylene, map, or natural gas.

The PPS - 2AF is an airflow meterdesigned to control the airflow to the WireJet Series of guns, it is a direct replacement for the Metco 2AF.

airtrio

AirTrio

The Air Triois designed for the WireJet series gun, it has a particle filter, water trap and air pressure regulator built into one unit. There is an additional quick disconnect for cooling air jets or other auxiliary compressed air requirements.

PowderJet 86, replaces 6PII

PF 700

PF 700, use with PowderJet 86

The PowderJet 86 is intended for higher production applications. It is similar to the PowderJet 85 except it uses a powder feeder for significantly larger volumes of powder for larger production applications.