Combustion Powder

PowderJet 85

A combustion powder system uses a combustible gas mixed with oxygen to create a flame outside of the spray gun of approximately 5500 F.  This is the heat source to melt the material to be sprayed.  The material to be sprayed is in the form of a powder that is fed into the center of the flame where it is melted.  Once it is melted in the flame, the liquid metal is atomized from a combination of the pressure from the flame and compressed air that is injected around the flame.  The atomized molten metal now forms a columned stream, similar in appearance to a spray paint pattern, except this is molten metal.  The molten stream of metal is deposited on the component to be coated at a thickness of .0005" (.0127mm) per pass to .003" (.0762 mm) per pass. The variation of thickness per pass is depended on the material being sprayed and the amount of heat build up on the part being coated.

The complete system includes the combustion powder gun complete in a metal case, gas flow meters, air flow meters, air trio, airjet assembly, vibrator, transformer, gas regulators, and flash back arrestors. When you purchase the complete system from us we include a set of free hoses. 

PPS-2GF               PPS-2AF

The PPS-2GF will control oxygen and fuel and is required to control the flow of gases for the WireJet series and the PowderJet series of guns. It is a direct replacement for the Metco 2GF. The standard system is configured to use acetylene and oxygen, optional hardware is available to use propane, propylene, map, or natural gas. 

The PPS - 2AF is an airflow meter designed to control the airflow to the WireJet Series of guns, it is a direct replacement for the Metco 2AF.

AirTrio

The Air Trio is designed for the WireJet series gun, it has a particle filter, water trap and air pressure regulator built into one unit.  There is an additional quick disconnect for cooling air jets or other auxiliary compressed air requirements.

PowderJet 86, replaces 6PII

PF 700, use with PowderJet 86

The PowderJet 86 is intended for higher production applications.  It is similar to the PowderJet 85 except it uses a powder feeder for significantly larger volumes of powder for larger production applications.

PowderJet Parts

Direct replacement parts for Metco 5PII and 6PII

Siphon Plug Assembly                            Nozzle                      

Valve Core                                      Air Cap            

O Rings

Baffles